Fresh
Aero FlightLights
Comparing Light Emitting Diodes and Incandescent Light Bulbs
The primary advantage of converting incandescent lighting to light emitting diodes (LEDs) is the considerable reduction in power consumption. LEDs use a fraction of the power used by incandescent bulbs.
When comparing LED lighting to a regular incandescent filament lamp there are a couple of issues to consider. The first is that for general lighting, a single LED is normally not quite as bright as an incandescent lamp. This is normally solved by grouping several LEDs together to reach the desired light output while still consuming far less power than equivalent incandescent lighting. For example, in an LED traffic signal, the number and positioning of numerous singular LEDs provides a unit light output far greater and with far better overall performance than the traditional incandescent light bulb -- and with considerably less power consumption.
Fresh Aero FlightLights utilize the multiple LED approach to produce a single high intensity light source that far surpasses the output of the typical 12 volt incandescent light bulbs in aircraft. And this is achieved with a fraction of the power required for the equivalent incandescent light bulb.
More LED Lighting Advantages - State of the art LED solid state lighting in blue, red green and white
- When you go with LED technology, you go green. LEDs sip a fraction of the power of other forms of lighting.
- Virtually no heat build-up. Unlike most lighting products , practically all electrical energy is converted into light.
- Very long life cycle. LEDs, when used correctly, have an approximate life span of 60,000 to 100,000 hour - about 6 to 11 years of continuous on use.
- Virtually vibration proof
- Many times brighter than most original cockpit/cabin lighting with significantly less power consumption. Just bright, clean and even light - with no halos, gaps or weak spots. Makes reading instruments, maps and other printed material a joy!
This 31 inch LED light bar adheres to the lower brow panel on Grumman AA-1 & AA-5 series aircraft and plugs into the existing incandescent bulb sockets in the eye brow. The EasyBrow installs quickly and easily with absolutely no modifications to the aircraft wiring. They are fully adjustable from dim to very bright with your existing dimming control and flood the panel with uniform light. Available in blue, red & green. read more
other aircraft
The EasyBrow lights are also available for other aircraft. We focus on the homebuilt market but these lights are great for certified aircraft too, with a FAA field approval. We offer the EasyBrow Lights in unlimited lengths (2 inches & up) with the wire leads soldered and shrink wrapped, ready for installation on your aircraft. These light can be mounted just about anywhere you need bright even light.
The FlightLights Goose Light utilizes four high intensity light emitting diodes to provide superior nighttime cabin and panel lighting and can be configured for both 12/14 and 24/28 dc voltage requirements and unlimited gooseneck lengths to completely satisfy your interior lighting needs. goose Lights are available in four LED colors -- blue, red, green and white. read more
aircraft
If you fly your Grumman AA5 series aircraft at night, you know that the original overhead cockpit/cabin lighting leaves a lot to be desired. We have the perfect solution! Just replace the original miniature incandescent light bulbs and outer panel with the Fresh Aero Easy Light in about 5 minutes. The Easy Light just plugs in! Absolutely no changes to your aircraft wiring read more
other aircraft
We also offer our Easy Lights for homebuilt and other aircraft that have cabin ceiling or canopies that can accommodate this type of unit. The Easy Light will greatly enhance your interior lighting. Easy Lights are available in any combination of four LED colors -- blue, red, green and white.
The Map Light replaces the existing gooseneck map light & housing on late AA5 Series Grumman Aircraft with a 4 LED assembly in an aluminum housing. Available in four LED colors - red, blue, green or white and two housing finishes - polished black or brushed aluminum. Very simple installation - just screw out the existing housing and bulb and screw on the Map Light.
TRi nav LED wingtip Nav lights
We have completed prototyping/testing and we're introducing our new Tri Nav Wingtip LED Nav Light system for Sonex aircraft now. A combination of innovative features, quality and price produce a wingtip LED nav lighting system that’s tough to beat. Also,these nav lights are perfect all hombuilts. We mold the Tri nav bases in our shop in Middle Tennessee and we can configure the bases to conform to any other wingtip contour.
Clip Lights
These clip-on LED lights are perfect for all-around lighting and are especially useful in the cockpit for auxiliary and emergency lighting applications. The heavy duty 8-position ratchet clip provides 360 degree positioning and clips to just about anything including hat visors, watch bands, eyeglass frames & clipboards. The light is bright and clean and the included lithium battery provides power that lasts a long, long time.
These 4 LED flashlights are the base for our Goose Light and Easy light systems and are great for aviation use, in and out of the cockpit. They have polished anodized aluminum housings and heads and operate on 3 AA batteries (included). These lights turn on and off by twisting the head and are available with red, blue, green or white LEDs.
The Articulight is a self contained overhead light package that uses rechargeable batteries to brighten up any cockpit/cabin environment. Available in with blue or red LEDs and with built-in switch & dimmer, the Articulight will pivot 90 degrees to focus bright pure light on your panel or cabin area. Coming soon.
read more